New · Panasonic RAC Solo with nanoe™ X
Air conditioning with nothing outside.
RAC Solo cools and heats a room from one slim wall unit, 16.5 cm deep. No outdoor box and no refrigerant pipework, just two neat holes through an outside wall.
Questions? Call Mr. Sony on +44 7767 578312
Four capacities
Pick the RAC Solo that fits your room.
Every model cools and heats, runs on a standard 230 V supply and shares the same 549 mm height and 165 mm depth. The difference is output — from 1.73 kW for a bedroom or study to 2.87 kW for a living room.
Suggested model
Good fit for a double bedroom or home office.
Room sizes are a guide for a typical UK room with a standard 2.4 m ceiling. Sun-facing glazing, poor insulation, high ceilings or a busy kitchen all push the requirement up, so we confirm the right size on a free survey before anything is ordered.
nanoe™ X · Generator Mark 3
Cleaner air, working even while it's quiet.
nanoe™ X technology releases hydroxyl radicals wrapped in water — tiny, long-lasting particles that travel through the room and onto surfaces. It's built into all four RAC Solo models.
hydroxyl radicals released per second by the Mark 3 generator — around 100× the original nanoe™.
Helps inhibit certain bacteria, viruses, mould and allergens in the air and on surfaces.
Breaks down everyday smells — cooking, pets, smoke — rather than masking them.
Particles are small enough to reach into soft furnishings and fabrics, not just the air near the unit.
Can run on its own, independent of cooling or heating, so the room is treated year-round.
nanoe™ X is not a medical device. Effects were verified by Panasonic in controlled laboratory conditions and vary with room size, ventilation and use. nanoe™ and nanoe™ X are trademarks of Panasonic Corporation.
Installation
Fitted from inside, usually in a day.
RAC Solo is a sealed, self-contained unit, so there's no refrigerant pipework to run. All it needs is an outside wall to breathe through — high on the wall or down at floor level.
Free survey
We measure the room, check the wall build-up and confirm the model.
Two core holes
Drilled from inside with a template — 162 mm (202 mm for the Solo 30), 293 mm apart.
Mount and connect
Chassis fixed, unit hung, external grilles fitted. Plugs into a standard 230 V supply.
Set up and hand over
Wi-Fi paired to the app, remote set up, and a walk-through of every mode.
Everyday details
Made to disappear into the room.
Self-closing grille
The air outlet opens only while the unit runs, then closes to a clean, flat front.
Wi-Fi built in
Control from your phone with the Panasonic Aquarea Home app, or use the on-board display and IR remote.
No-frost system
A pre-heated condensate tray keeps heating running in cold snaps, down to −15 °C outside.
DC Inverter
Speeds up and slows down to hold the temperature steadily, instead of cycling on and off.
Dehumidifies
Pulls 0.7–1.2 litres of moisture an hour out of the air, depending on the model.
Lower-GWP refrigerants
Solo 16 uses natural R290; Solos 20, 25 and 30 use R32. Sealed at the factory, never handled on site.
Technical data
Full specifications.
Figures from Panasonic's 2026 residential catalogue. The model suggested by the room finder is highlighted.
EER and COP classes to Regulation 626/2011 (scale A+++ to D); SEER and SCOP to EN 14511. Sound pressure measured at 2 m to ISO 7779. Rating conditions: cooling 27 °C DB / 19 °C WB indoor, 35 °C DB / 24 °C WB outdoor; heating 20 °C DB indoor, 7 °C DB / 6 °C WB outdoor. Specifications may change without notice.
Questions
Good to know before you book.
Is it as powerful as a split system?
RAC Solo is sized for single rooms up to around 30 m². For larger open-plan spaces a split system, or two Solo units, will usually be the better answer — we'll tell you honestly on the survey.
How loud is it outside?
The grilles are the only thing outside. Sound pressure at 2 m ranges from 36 dB(A) on low to 49–53 dB(A) on high, depending on the model.
Will it heat my room in winter?
Yes. Every model works as a heat pump, keeps running down to −15 °C outside, and still delivers 1.13–1.81 kW of heat at −7 °C.
Where can it go on the wall?
High on the wall or down at skirting level, in the middle of a wall or near a corner — as long as it's on an outside wall. If the wall behind it isn't external, a side-exit kit can redirect the airflow.
What about condensate?
Condensate is handled through the wall. On heating models an extra small drain may be needed; we check this, and whether a drain-pipe heater kit is worthwhile, during the survey.
How much does it cost?
Pricing depends on the model, wall construction and access, so every job is quoted after a free survey. Send an enquiry below and we'll come back with a fixed price.
Price on request
Get a fixed quote.
Tell us about the room and we'll arrange a free survey. Call Mr. Sony directly, or fill in the details, copy your enquiry and send it by email.
Surveys across Greater Manchester and the North West. Mon–Fri, 8am–6pm.